
24
10.3 LIFTING MANOEUVRES
1. Be sure that the tabletop is at the lowest position and the run-up ramp is
correctly fitted.
2. Load the bike on the tabletop through the run-up ramp.
3. Place the bike on the centre stand (if the bike does not have any, use one
of our rear paddock stand). Never raise bikes with side stand.
4. Fasten the bike with suitable fastening belts (option). The bike must be
stable on the tabletop.
CAUTION: Before raising the load, be sure that you have fixed it to the
tabletop with fastening belts.
5.
Hydraulic foot pump. Press the foot lever.
Hydro-pneumatic unit. Press the ascent button.
Electro-hydraulic unit. Press the ascent button.
6. Do not expose the load to dangerous slope. Make sure that the load does
not get unbalanced while lifting the table.
7. Once you have reached the required working height, slightly lower the Lift
to allow the safety bar to be positioned on the safety locking choices.
CAUTION: Never operate when the safety bar is disconnected.
8. The run-up ramp is removable to allow Technicians to have free access to
the rear side of the bike easily.
Summary of Contents for Cruiser 750
