bihl+Wiedemann BW 3023, User Manual

Page: 21 / 24

C-Series AS-i Master Module
Appendix: Codes indicated by the Display
Subject to technical modifications; no responsibility is accepted for the accuracy of this information © Bihl+Wiedemann GmbH 21
Internet: www.bihl-wiedemann.de • Flosswoerthstr. 41 • D-68199 Mannheim phone: +49 621 33 996-0 • fax: +49 621 3 39 22 399
Is
s
ue da
te: 1
6
.4.2
015
8. Appendix: Codes indicated by the Display
Bihl+Wiedemann AS-i error codes and warnings are in the range: Range +/-
389000 to 389099. Errors explanations can be found with the NI LabVIEW envi-
ronment by clicking Help "Explain Error". A list of error codes is shown below:
Code Name Description
-389000 asiErrorAnalogInvali-
dAddress Slave address for the analog read or write is
invalid. Solution: Specify an address in the range
of 0 to 31.
-389001 asiErrorAnalogInvalid-
DataLength The data length of four 16-bit analog channel is
out of range. Solution: Make sure the data length
is within 8 bytes.
-389002 asiErrorAnalogOpera-
tionTimeout Analog read or analog write timed out. Solution:
Increase timeout and ensure "AS-i Commit.vi"
has been called.
-389003 asiErrorCommandInval-
idRequestLength Command request size is out of range. Solution:
Make sure the length of command request is
smaller than 39 bytes.
-389004 asiErrorCommand-
Timeout Timeout occurred waiting for the command
response. Solution: Increase timeout and check
hardware connection.
-389005 asiErrorDigitalInvali-
dAddress Slave address for digital read or digital write is
invalid. Solution: Specify an address which is in
the range of 0 to 63.
-389006 asiErrorDigitalInvalid-
Data Digital data value is invalid. Solution: Specify a
value in the range of 0 to 15.
-389007 asiErrorDigitalInvalid-
DataImageLength Digital data image size is out of range. Solution:
Make sure the length of digital data image is
smaller than 33 bytes.
-389008 asiErrorSpiFrameData-
Fault CRC check failed between backplane and mod-
ule. SPI communication may be corrupted by
electrical noise. Solution: Reduce noise and con-
tact National Instruments if the error persists.