Big Joe PDBB-20-T12, Operation, Maintenance, Repair Parts List

Page: 43 / 114

901357 5-5
6. With a pair of vise-grip pliers, grip the flat surfaces
of spring tube assembly (4), and slowly pull it free
from the steering arm, pivot cap and tube clamp
(13).
NOTE: Steering arm return spring (5) will remain
inside the spring tube assembly (4).
7. Remove steering arm return spring (5) from
spring tube assembly (4).
8. Lubricate the ends and outer surface of the new
steering arm return spring (5) with a lithium base
general purpose grease.
9. Insert spring into spring tube assembly and press
in, making sure that one spring loop eye fits over
the roll pin at the closed end of the spring tube
assembly.
10. Slide spring tube assembly into pivot cap (14) and
steering arm (10) through tube clamp (13) and
through loop of electrical cable.
11. Align radial position of spring tube assembly in
accordance with line drawn in step 3. Slowly
rotate spring tube assembly a few degrees each
way until the steering arm return spring snaps into
place over spring pins (11 and 12) then tighten
screw (1).
12. Apply engine lubricating oil (No. 2) to the steering
arm elbow.
13. Remove block from under steering arm.
14. Adjust tension on steering arm return spring as
explained in paragraph 5-6.
15. Reconnect battery.
Figure 5-4 Steering Arm and Electrical Cable
R6183
HANDLE RETURN SPRING KIT
PART NUMBER 901325
CONTAINS:
ITEM QTY
4 1
5 1
6 2
7 2
11 1
12 1