Big Backyard ORIANA A24656E, Installation And Operating Instructions Manual

Page: 18 / 40

Step 8: Attach Gussets
4 x #8 x 1-1/2” Wood Screw
4 x 1/4 x 3” Lag Screw
(1/4” flat washer)
1 x Gusset 5/4 x 4 x 18-1/2”
2 x Floor Gusset 2 x 3 x 11”
Fig. 8.2
OR4
Fig. 8.3
Fig. 8.4
OR5
LS3
OR4
LS3 LS3
Note: Pre-drill all holes using a 1/8” drill
bit before installing the lag screws.
Predrill Pilot Holes for Lag Screw
Lag
Screw
Flat
Washer
Predrill 1/8”
pilot hole
Use factory drilled
hole as a guide
Fig. 8.1
S2
OR5
OR4
LS3
S2
Hardware Wood Parts
F13
OR4
F13
F17
F12
Under fort view
F6
1”
A: On the Swing Wall side place 1 (OR4) Floor Gusset tight to the bottom of the (F6) Cedar Gap Board make sure
assembly is square, then attach to each (F13) Post with 1 (LS3) 1/4 x 3” Lag Screw (with flat washer) per gusset in
the pre-drilled holes as shown in fig. 8.1, 8.2 and 8.3.
B:
Attach each (OR4) Floor Gusset to (F17) End Floor using 2 (S2) #8 x 1-1/2” Wood Screws per gusset. (fig.
8.2)
C:
Place 1 (OR5) Gusset tight to the bottom of (F12) Floor Front so there is a 1” overhang from the outside edge
of (F13) Post. (fig. 8.1 & 8.4)
D:
Attach (OR5) Gusset to (F13) Post with 1 (LS3) 1/4 x 3” Lag Screw (with flat washer) from inside the assembly
and then to (F12) Floor Front with 1 (LS3) 1/4 x 3” Lag Screw (with flat washer) as shown in fig. 8.4.
18