26
Step 10: Swing Wall Assembly
Part 2
Note: Pre-drill all holes using a 1/8” drill bit before installing the lag screws.
C:
Place (2034) Wall Support on both (1931) Posts as shown in fig. 10.2.
D:
Place (2035) SW Mount across (1895) Floor End, (2034) Wall Support and (2030) Side Roof. Loosely attach
using 3 (G4) 5/16 x 4” Hex Bolts (with lock washer, flat washer and t-nut) as shown in fig. 10.2.
E:
Make sure assembly is square and then fasten (1895) Floor End to (1931) Posts in the top holes using 2
(LS1) 1/4 x 1-1/2” Lag Screws (with flat washer); and (0369) Lower Diagonals to (1931) Posts with 1 (LS3) 1/4 x
3” Lag Screw (with flat washer) per diagonal. (fig. 10.2 and 10.3)
F:
Make sure (2034) Wall Support is square to the posts then attach to both (1931) Posts using 4 (S2) #8 x
1-1/2” Wood Screws. (fig. 10.3)
G:
Tighten all bolts, except for the (2035) SW Mount bolts, from this step.
Wood Parts
Hardware
Fig. 10.2
Fig. 10.3
5/16” Flat
Washer
5/16” Lock
Washer
5/16”
T-Nut
1931
1895
2034
2030
2035
G4
LS3
1/4” Flat
Washer
0369
1931
1895
2034
S2
1/4” Flat
Washer
3 x
5/16 x 4” Hex Bolt (5/16” lock washer, 5/16” flat washer, 5/16” t-nut)
2 x
1/4 x 1-1/2” Lag Screw (1/4” flat washer)
2 x
1/4 x 3” Lag Screw (1/4” flat washer)
4 x
#8 x 1-1/2” Wood Screw
1 x
Wall Support 1 x 4 x 35-7/8”
1 x
SW Mount 2 x 4 x 59-1/2”
2034
S2
2035
LS1
G4
LS3
1931
LS1
