Big Backyard BALMORAL A24655E, Installation And Operating Instructions Manual

Page: 13 / 40

Step 3: Swing Wall Assembly
B:
Make sure assembly is square and then fasten (F17) End Floor to (F13) Posts in the top holes using 2 (LS1)
1/4 x 1-1/2” Lag Screws (with flat washer). (fig. 3.2)
C:
Attach (F11) Lower Diagonal to (F16) SW Ground with 1 (H2) 1/4 x 2” Hex Bolt (with lock washer, flat washer
and t-nut) and to (F13) Post using 1 (LS3) 1/4 x 3” Lag Screw (with flat washer). (fig. 3.2)
D: Tighten all bolts.
Note: Pre-drill all holes using a 1/8” drill
bit before installing the lag screws.
Hex Bolt Assembly
Lock
Washer
T- Nut
Flat
Washer
He x
Bolt
Predrill Pilot Holes for Lag Screw
Lag
Screw
Flat
Washer
Predrill 1/8”
pilot hole
Use factory drilled
hole as a guide
Fig. 3.1
F17
F13
F16
Notice hole
positioning
F14
LS1
Fig. 3.2
F13
H2
H2
H2
F16
H2
F11
LS3
1 x End Floor 1 x 5 x 38-1/4”
1 x SW Ground 1 x 5 x 77”
1 x Lower Diagonal 2 x 3 x 37”
2 x Post 2 x 4 x 83”
1 x Wall Support 1 x 4 x 38-1/4”
F17
F16
F11
F13
F14
Hardware
Wood Parts
9 x 1/4 x 2” Hex Bolt
(1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
1 x 1/4 x 3” Lag Screw
(1/4” flat washer)
2 x 1/4 x 1-1/2” Lag Screw
(1/4” flat washer)
H2
LS3
LS1
A:
To 2 (F13) Posts attach 1 (F16) SW Ground with 4 (H2) 1/4 x 2” Hex Bolts (with lock washer, flat washer and
t-nut); 1 (F17) End Floor in the bottom holes and 1 (F14) Wall Support with 2 (H2) 1/4 x 2” Hex Bolts (with lock
washer, flat washer and t-nut) in each board. (fig. 3.1)
Fig. 3.2
F16
H2
F11
LS3
H2
F13
LS1
13