Big Backyard BALMORAL A24655E, Installation And Operating Instructions Manual

Page: 11 / 40

Step 1: Rock Wall Assembly
A:
Lay 2 (BR1) Rock Rails down, side by side with angled edges facing down. (fig. 1.1)
B:
Place (F1) CE Access Board on the bottom of each (BR1) Rock Rail as shown in fig. 1.1. Make sure (F1) CE
Access Board is square and flush to the outside and bottom edges of each (BR1). Attach using 4 (S2) #8 x 1-1/2”
Wood Screws.
C:
8-1/8” down from the top of both (BR1) Rock Rails place 1 (F3) CE Rock Board, making sure the sides are flush
to the outside edges of each (BR1) Rock Rail. Attach using 4 (S2) #8 x 1-1/2” Wood Screws. (fig. 1.1)
D: In between the (F1) CE Access Board and (F3) CE Rock Board stagger 2 (F4) and 2 (F3) CE Rock Boards
using 4 (S2) #8 x 1-1/2” Wood Screws per board. Placing them as shown in (fig. 1.1), this will prevent rocks from
forming a straight line. Make sure the gap between boards are spaced 2-1/8” and does not exceed 2-3/8”.
E: Place 1 rock on each (F3) and (F4) CE Rock Board
(fig. 1.2) and attach using included hardware. The
screw must be in the hole directly under the Pan Bolt, it
will stop the rock from spinning. (fig. 1.3)
F1
F3
F3
F4
F3
F4
BR1
Fig. 1.1
Pan Screw
Pan Bolt
Flat
Washer
Rock
Barrel Nut
Lock
Washer
Fig. 1.3
Note: Gaps between boards 2-1/8”,
not to exceed 2-3/8”
Note: The holes
in the rock boards
must orient to the
top of the boards.
x 4 per
board
Bottom
8-1/8”
approx.
1 x CE Access Board 1 x 6 x 19-3/4”
3 x CE Rock Board 1 x 6 x 19-3/4”
2 x CE Rock Board 1 x 6 x 19-3/4”
2 x Rock Rail 2 x 3 x 51”
F1
F4
F3
BR1
24 x #8 x 1-1/2” Wood Screw
S2
5 x Rocks (with hardware)
Hardware Other Parts Wood Parts
Fig. 1.2
S2
11