BIG ASS FANS Haiku A0 Series, Installation Manual

Page: 15 / 48

HAIKU by Big Ass Fans
11
Powering the fan
To turn the fan on or off,
press the On/Off button on the fan remote.
This button can also be used to reset the fan’s speed.
The remote must be
pointing toward the fan mode indicators to function properly.
The fan will automatically restart at the last operating speed
upon connection to the power source!
Replacing the remote control battery
The Haiku remote control operates on a CR 2025 3V lithium battery. To
replace the battery, on the bottom of the remote, push the small tab
to the right while sliding the battery tray outward. Replace the battery,
and then close the battery tray. Recycle or dispose of the old battery
properly.
Changing fan speed
Fan speed is increased or decreased by pressing the Up or Down
Speed button on the remote. Seven fan speeds are available to
accommodate your comfort level.
To change the fan speed, press a Speed button. The Up Speed
button increases fan speed; the Down Speed button decreases fan
speed. Press and hold a Speed button to step through the speeds
automatically. The fan mode indicators will illuminate and a short beep
will be heard until speed 7 (high) or 0 (off) is reached.
Sleep mode
Sleep mode reduces the fan speed by one increment every hour until
the lowest speed is reached. When the programmed time period ends,
the fan automatically turns off.
Sleep mode is only active when Timer
mode is used.
To activate Sleep mode, set the fan speed and Timer mode, and then
press the Sleep button. The Sleep indicator will illuminate. To exit Sleep
mode, press the Sleep, Clear, or On/Off button.
Timer mode
In Timer mode, the fan runs at a set speed until the programmed time period ends. Note: Timer mode
is disabled if the fan speed is 0 (off) or if the fan is not running.
To set Timer mode, press the Timer button 1–7 times (once for each hour) to program the end time.
During adjustment, the fan mode indicators will flash, and then the Timer setting is displayed on the
speed indicator bar.
To exit Timer mode, press the Clear button.
Whoosh mode
Whoosh mode simulates natural, relaxing breezes by automatically varying the fan speed in a quasi-
sinusoidal pattern.
To activate Whoosh mode, set the desired maximum fan speed, and then press the Whoosh button.
The top Speed indicator will flash to indicate that Whoosh mode is active.
To exit Whoosh mode,
press
the Whoosh, Speed, or On/Off button once.
Before using the Haiku remote control, remove the plastic tab in the battery tray.
The fan mode indicators are located on the bottom of the fan hub when
viewed from the floor.
3.4” (86 mm)
1.2” (33 mm)
!
Remote Front
Remote Back
Operation
tip!