WWW.BIGASSFANS.COM
6
CONNECTING THE LED DRIVER
CAUTION: To prevent electrical shock, do not mate the unit connector until
installation is complete and AC power is applied to the unit.
E1.
After installation is complete, turn on AC power, and then join the driver unit
connector on top of the fixture.
E2.
Push the unit connector and wiring into the hole.
E3.
Snap the red button into the hole. Make sure the button is illuminated. This
indicates the driver is charging.
Figure E
Figure E1
TESTING THE LED DRIVER
Allow the driver battery to charge for one hour, and then press and hold the
button to conduct an initial emergency lighting test. The light should turn off and
half of the LEDs should illuminate at a dim level.
Allow the battery to charge for 24 hours, and then switch off AC power at the
circuit breaker to simulate a blackout. Make sure half of the LEDs operate at a dim
level for 90 minutes.
Figure E2
Figure E3
