ANEM Operating Manual
ANEM Operating Manual
Page 11
To listen to the demonstration modes, or change the
number of DSP levels it is necessary to put the module
into the set up mode.
To do this, ensure the module is Off. Press and hold the
DSP level button. Turn on the module and a 2 tone beep
will be heard indicating that the module is in the set up
mode.
Releasing the button after the first 2 tone beep will enter
demonstration mode 1.
Releasing after the second 2 tone beep will enter
demonstration mode 2.
Releasing after the third 2 tone beep will set the unit to
level 2 in the 4 level mode.
After the fourth beep, keep the button depressed. 4 beeps
will indicate 4 level mode and 8 beeps 8 levels. Release
the button to select the desired level mode.
The module will return to normal operation after this.
The colour of the LED will indicate the mode of operation,
red for 4 level and orange for 8 level.
e
d
o
m
P
S
D
s
l
e
v
e
L
4
s
l
e
v
e
L
8
F
F
O
D
E
R
E
G
N
A
R
O
N
O
N
E
E
R
G
N
E
E
R
G
Table 1. LED mode indication.
3.
Module Operation.
Page 18
4.1 Module Layout.
Figure 14. ANEM PCB and controls
Input
level set
(P2)
Output
level set (P1)
Input overload
indicator LED
Audio
bypass
relay
Note:
Wiring and heatsink obmitted for
clarity
Sounder
volume (P3)
4.
Technical Information.
The following diagram shows the internal layout of the
ANEM
printed circuit board.
In order to access the printed circuit board the case needs
to be removed.
Carefully pull the sides of
the case outwards, until the
upper section can be
removed. When re-
assembling the module
enusre that none of the
wires become trapped in
the case halves.
Figure 13. ANEM case dis-assembly detail.
4. Technical Information.
