ANEM Operating Manual
ANEM Operating Manual
Page 7
2.3 Mounting options.
The
ANEM
can be used on the bench, or attached to your
loudspeaker using the velcro strips supplied.
For bench mounting attach the four rubber feet to the
bottom of the module as shown.
4 off rubber feet
fit over case screws
hook and eye fastener
strip
Mount it on the side...
..on the top..
..on the back..
..or use it on the bench...
2.
Module Over
view
.
Figure 4. Mounting options
If the module is going to be mounted on the loudspeaker
then attach the strip of hook and eye fastener as shown
below.
Page 22
Figure 17. Circuit modification for low power signal drive.
4.4 Driving from a low signal source.
Cut the
leg on this
resistor
22
W
OUT
12
Agnd
Agnd
9
10
Load
V
Audio
Input
R6
IN
11
Circuit
modification
Figure 16. Physical modification for low power signal
drive.
Note:
Wiring and
heatsink
omitted for
clarity.
4.
Technical Information.
The input to the module has a low impedance. This is to
provide correct loading to any power circuits driving it. If
the module needs to be driven from a low power signal
then it must be modified in the following manner. The case
must first be removed, as described in section 4.2.
