15
3. Cool-down phase
This phase allows the cardiovascular
and muscle system to relax. It consists
of repeating the warm-up exercises,
i.e. reducing the rhythm and
continuing for approximately 5
minutes. Repeat the stretching
exercises but remember not to
overexert the muscles.
Eventually your training sessions will
have to become longer and more
intensive. It is advisable to exercise at
least three days per week, on
alternate days.
Muscle toning
You should select a high exertion level
in order to tone muscles during
exercise. This entails greater stress on
the leg and arm muscles, so it may be
wise to reduce exercise times. If you
also wish to improve your overall
fitness then you should change your
training program. Do the warm-up and
cool-down exercises as normal but
when you are reaching the end of the
exercise phase, increase the exertion
level in order to make your legs work
harder. You should reduce speed in
order to keep your heart rate within
the target area.
ASSEMBLY INSTRUCTIONS.-
Take the unit out of its box and make
sure that all of the pieces are there:
The assistance of a second person
is recommended when assembling
this unit.
Take the components out of the box
and make sure that you have all of the
pieces, Fig.1:
(1) Front rest support.
(2) Rear rest support.
(3) Front support.
(4) Rear support.
(5) Backrest support.
(6) Backrest positioner support.
(7) Seat support.
(8) Seat positioner support.
(9) Vertical leg bar.
(10) Foam tube
(11) Leg support safety pin.
(13) Backrest.
(14) Seat.
(15) Lock pin.
(16) Screw caps.
(22) Foam.
(23) Screws M-8x16.
(24) Screws M-8x55.
(25) Screws M-10x20.
(26) Screws M-10x95.
(27) Screws M-10x125.
(28) Screws M-10x158.
(29) Screws M-10x180.
(30) Washers M-8.
(31) Flat washers M-8.
(32) Washers M-10.
(33) Flat washers M-10.
(34) Self locking nuts M-10.
ASSEMBLY.-
1-
Position the front rest support (1) on
the front rest (3) Fig.2.
Fit the corrugated washer (32) and nuts
(34) and tighten securely.
Place the trim caps (16) over the nuts
(34), as shown in Fig.2.
2-
Position the back rest support (2) on
the back rest (4) Fig.3.
Fit the corrugated washer (32) and nuts
(34) and tighten securely.
Place the trim caps (16) over the nuts
(34), as shown in Fig.3.
Summary of Contents for Optima G320
