19
VERY IMPORTANT
: you may not regrind and reuse the same ham-
mers for more than two times. To regrind, dismount and take the
hammer off the machine, regrind using a suitable sharpener and final-
ly fit the hammer back in.
To replace a hammer follow the instructions below:
• Release (without fully removing) the 4 fixation screws (SW15) and
remove the upper infeed hopper (see figure 15). When doing this,
remember to first pull out the threaded stud of the safety switch.
• Release the 4 hex nuts (SW13) and remove the side spout (see „Fi-
gure 19“).
• Unscrew the V-belt cover (SW10) (see „Figure 20“).
• Turn the rotor till the hammer pivots becomes visible through the
opening.
• Release and pull out the countersunk screw (SW 6) of the hammer
pivots (see „Fig. 21“)
Fig. 18
Fig. 19
Fig. 20
Fig. 21
