Insructions manual
BBS 500 B
2014-05-05
6.2. Lubricating plan
Lubrication should only be done with suitable lubricants recommended by the
manufacturer of lubricants
Recommended lubricant:
1, 2, 3, 4......Mogul LV 2-3, after every 40 hours of
operation
5.......engine oil according to the user manual for
engine, the first change after 20 operating hours,
next after every 100 hours of operation.
Description of lubrication points:
1. Grease nipple of tensioning body
2. Grease nipple of tensioning wheel
3. Grease nipple of driving wheel
4. Lifting chain
5. Engine oil filling
7. Saw bands
7.1. Safety regulations
When.unpacking.or.packing.and.during.manipulation.(e.g..when.
installing.the.machine),.proceed.with.caution!.Risk.of.injury.by.
very.sharp.cutting.edges!.Whenever.you.manipulate.with.the.saw.
blade,.wear.protective.gloves.and.goggles!
Transport.tool.in.an.appropriate.container!.Risk.of.injury!
Carefully.clean.the.wheels.and.guides..Inspect.the.cutting.edge..Check.the.
adjustment.of.the.machine..Do.not.exceed.the.minimum.and.maximum.tensioning.
force!.The.tool.must.be.installed.and.secured.in.accordance.with.regulations.of.the.
machine manufacturer. Improper use and use of inappropriate purpose is prohibited
7.2. Instructions for tool operation
• The main prerequisite for a good machine performance and achieving precise dimension of lumber are the good
quality saw bands.
• Drive into the work piece slowly and only then when the saw band has reached the full operating speed.
• Try to find the optimum feed speed for cutting. For the low feed speed, the saw band becomes quickly blunt, while
under a heavy pressure to the cut, the cut is crooked and the saw band earlier bursts.
• Do not let the saw band idle. After work, release the saw band tension.
• Store unused saw bands hanging freely in a safe, dry place, and before using them, the saw bands clean and
check for cracked and damaged teeth.
The.machine.is.designed.to.be.fitted.with.the.bi-metal.saw.band.which.is.commonly.used.on.saw.
bands.for.metal..This.saw.band.is.not.sharpen.and.set.in.operation,.after.blunting.is.exchanged.
for a new one
Recommended.type.of.saw.band:.. Bi.METAL.M42.dimension.3330x27x0,9.mm,.pitch.3.teeth.per.1´´.
Saw band design
page 27 /
49
5
20/100
SUPPORTING STEEL BAND MADE
OF ALLOY AND TEMPERED STEEL
27 mm
cca 1 mm
LASER WELDING HEAD
TOOL STEEL
