page 26 /
49
Insructions manual
BBS 500 B
2014-05-05
6. Preventive maintenance of machine
6.1. Maintenance and inspection
Perform.maintenance.work.only.if.the.bridge.with.the.saw.band.arm.is.in.
the.parking.zone,.engine.is.not.running.and.the.ignition.switch.is.turned.off
Risk.of.injury
To maintain the functionality of the machine and its components, it is absolutely necessary the
care.and.maintenance!
Maintenance.is.performed.by.the.user!
The maintenance plan
Plan your maintenance according to the use of machines in operation. The procedure described below applies to
the maintenance of the machine in single-shift operation. If the machine is used in operation more often, you need to
plan maintenance more frequently.
Daily maintenance:
1. Clean and lubricate the guide rollers on the guide steel pipe for the arm lifting.
2. Clean and lubricate the chain for the arm lifting
3. Check all guards. Make sure they are intact and in good condition.
4. Clean sawdust from the inner part of the arm and the whole machine
5. Clean from sawdust and resin both belts in the shoulder area
6. Clean and inspect the saw band guides
7. Check the saw band cooling
8. Visually check the tightening of bolted joints
9. Visually inspect the cables and the throttle cable routing
10. Visually inspect the integrity of the V-belts
11. Check the function of clutch and brake
12. Fill the petrol in the tank
Risk.of.fire!.Gasoline.is.highly.flammable.and.when.refilling.may.result.in.
burns or seriously injure. Turn off the engine, near must not be resources
of.heat,.sparks.or.open.flames!.Wipe.up.spilled.fuel.immediately!
13. 13. Visually inspect all warning labels
Weekly.maintenance:
1. Make precisely all acts of Daily maintenance
2. Lubricate all components according to the Lubrication schedule (see Chapter 6.2.)
3. Make mechanical inspection of bolted joints
4. Make sure that the travel sections are firmly supported by all adjustable legs.
5. Check the V-belt tension (see Chapter 5.1.6.)
6. Check the clearance in the bearings of the drive and tensioning wheel (see Chapter 5.1.7.)
7. Check and possibly clean the electrical parts from the deposited dust
If faults occur that you are unable to remove using the instructions provided in this manual,
.call.service.(manufacturer,.distributor)!
.Consign.the.engine.repairs.to.an.authorized.Honda.service
