BFT SIRIO CBA 230 INV, Installation Manual

Page: 8 / 28

ACCESS MENUS Fig. 1
x 2
autoset
Exit Menù
Confirm/Switch on display
Scroll up
Scroll down
See PARAMETERS MENU
See LOGIC MENU
See RADIO MENU
add. start
hidden butt
hidden butt
release
release
desired button
desired button
Add. 2ch
erase 64
language
stat
- +
- +
OK
vers bft . . .
+
/
-
OK 0000
+
/
-
+
/
-
n. cycles
OK
OK
01.33
password
0---
10-- 150- 1520
prg
00
- +
err
02.01
........
30.15
+
/
-
n. remotes
List of last 30 errors
Control unit
software version
No total
manoeuvres(in hundreds)
No radio control
devices memorised
35.40
Obstacle threshold
Instantaneous force motor
Diagnostics
code
DESCRIPTION NOTES
STRE START E external start input activated
STRI START I internal start input activated
OPEN
OPEN input activated
CLS CLOSE input activated
PED PED pedestrian input activated
TIME
TIMER input activated
STOP STOP input activated
PHOT PHOT photocell input activated
PHOP
PHOT OP opening photocell input activated
PHCL PHOT CL closing photocell input activated
BAR BAR safety edge input activated
BAR 2
BAR safety edge input activated on slave motor
(opposite leaves connection)
SWC SWC motor closing limit switch input activated
SWO SWO motor opening limit switch input activated
SET
The board is standing by to perform a complete opening-
closing cycle uninterrupted by intermediate stops in
order to acquire the torque required for movement.
WARNING! Obstacle detection not active
ER01
Photocell test failed Check photocell connection and/or logic settings
ER02 Safety edge test failed Check safety edge connection and/or logic settings
ER03 Opening photocell test failed
Check photocell connection and/or param-
eter/logic setting
ER04 Closing photocell test failed
Check photocell connection and/or param-
eter/logic setting
ER05
Safety edge test on slave motor failed (opposite leaves
connection)
Check safety edge connection and/or param-
eter/logic settings
er06
8k2 safety edge test failed
Check safety edge connection and/or param-
eter/logic settings
ER1x * Board hardware test error
- C h e c k c o n n e c t i o n s t o m o t o r
- Hardware problems with board (contact
technical assistance)
ER2x * * Encoder error
- Motor power or encoder signal cables in-
verted/disconnected.
- Actuator movement is too slow or stopped
with respect to programmed operation.
ER3x
*
Reverse due to obstacle - Amperostop Check for obstacles in path
ER5x * Communication error with remote devices
Check connection with serial-connected
accessory devices and/or expansion boards
ER7x
*
Internal system supervision control error.
Try switching the board off and back on again
If the problem persists, contact the technical
assistance department.
ErF3
/
F4
/
F5
Inverter alarm
Check the inverter’s connections.
Check the inverter’s display for any error
messages
ErF1
/
F2 limit switch error check limit switch connections
*
X
= 0, 1, .., 9, A, B, C, D, E, F
8 -
SIRIO CBA 230 INV
D811948_01