2.3.10
Remove the pressure test point screw from the inlet elbow and fit a
manometer.
2.3.11
Turn on the main gas supply and carry out a gas tightness test as per
section 2.4
2.3.12
Fit the batteries to the battery box and handset as per section 3.2
2.3.13
Finish the surface covering around the opening as shown in section 2.5
2.3.14
Replace the burner tray cover as shown below in figure 20, the
ceramics as shown in section 3.1 / 3.2 as applicable and glass panel.
Replace the side trims which are retained by magnets and the front grill,
then proceed to section 3.3 (lighting the appliance).
Fig. 20
2.3.15
Secure the firebox to the opening via the fixing holes on the firebox
flange as shown overpage in figure 21.
16
