3.1.11
Complete a final check to ensure all logs are positioned as shown
below in figure 34.
Fig. 34
3.1.11
If required, fit the glow fibre material over the flame ports. To do this,
seperate into short strands and place randomly over the flame porting
area.
3.1.12
Refit the glass panel in reverse order to that as described in section
2.3.1 to 2.3.4, fit the batteries as shown in item 3.2 then light the
appliance as described as in section 3.3
IMPORTANT NOTE : PLEASE ENSURE THAT WHEN COMMISIONING THE
FIRE THE FLAME PATTERN IS EVEN ACROSS THE WIDTH OF THE BURNER.
IF AN UNEVEN FLAME PATTERN IS FOUND THEN RELAY THE QUANTITY
VERMICULITE TO ACHEIVE AN EVEN FLAME PATTERN.
Warning : Use only the logs supplied with the fire. When replacing the
logs remove the old logs and discard them. Fit a complete set of logs of the
correct type. Do not fit additional logs or any logs other than a genuine
replacement set.
This appliance does not contain any component manufactured from
asbestos or asbestos related products.
27
Log “D”
Log “H”
Log “E”
Log “A”
Log “C”
Log “B”
Log “G”
Log “F”
Log “I”
