Wireless Mini Analyser User Manual
Wireless Mini Analyser User Manual V1_06
1_04
31 of 32
RD096 071112
Parameter
Units
Conditions
Min
Typ
Max
Data Rate
kbaud
19.2
Communications Range
m
50
Transmit Power Level
dBm
2.5
Receiver Sensitivity
dBm
-96
Protocol
2.4GHz IEEE802.15.4 Compatible
9.6
Environmental
Parameter
Units
Conditions
Min
Typ
Max
Operating Temperature
Range
°C
-20
70
Lead-Free and RoHS compliant
Compliant with FCC part 15 rules, IC Canada, ETSI ETS 300-328 and Japan ARIB STD T66
FCC ID: TYOJN5139M0
IC: 7438A-CYO5139M0
These modules have been designed to operate with antennas having a maximum gain of 4.4 dBi. Antennas
having a gain greater than 4.4 dBi are strictly prohibited for use with this device. The required antenna
impedance is 50 ohms.
As long as the above condition is met, further transmitter testing will not be required.
Important Notice
User information according to
FCC15.21
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the
equipment.
b)
Statement for Class B digital device acc. to FCC 15.105
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
c) Statement acc. RSS Gen Issue 3, Sect. 7.1.3
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s). Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
