Bezzera BZ10, Instruction Manual

Page: 26 / 56

26
MOD.
BEZZERA BZ10
7 - TROUBLE SHOOTING
Problem Diagnostics/Solution Advice
No distribution of steam
from specific tube
The steam tube nozzle is blocked; unblock
it using a pin. This problem is linked to
the fact that the tip of the nozzle enters
the milk.
Clean the steam nozzle after
each use.
Leaks from filter holder Possible causes:
1 - The seal under the cup is worn or en-
crusted.
2 - The filter holder is placed incorrectly
on the unit.
Clean with the brush pro-
vided.
If the problem should arise
again, call a specialised
technician.
Difficulty in placing the
filter holder on the at-
tachment ring
The problem may be caused by the exces-
sive dose of coffee in the filter holder.
Reduce the amount of coffee
in the filter holder. (Standard
doses for filters are 6 grams
per dose).
Abnormal position of
filter holder once placed
on the unit.
Once locked onto the unit, the filter hold-
er handle is further to the right than usual.
The seal under the cup is worn.
Call a specialised technician
to replace the seal under the
cup.
Coffee flow is less than
usual
Coffee comes out in drops, distribution
time is too long and the quality of the cof-
fee is not good, it has a dark cream.
Possible causes:
1 - The coffee has been ground too fine-
ly.
2 - The coffee in the filter holder is pressed
down too hard.
3 - Too much coffee has been placed in
the filter holder.
4 - The unit shower is blocked.
5 - The filter in the filter holder is blocked.
In cases 1-2-3, the problem
can be solved by adjusting
the grinding and/or dosage
of the coffee.
In case 4, a technician must
be called.
In case 5, clean the filter or
replace it.
Coffee flow is excessive The coffee is distributed too quickly and the
cream is lighter than usual.
Possible causes:
1 - The coffee has been ground too coarse-
ly.
2 - The coffee in the filter holder is not
pressed down enough.
3 - There is too little coffee in the filter hold-
er.
Alter the coffee grinding and/
or dosage.