BEYERTONE
®
www.beyertone.com
© IV-2022 BEYERTONE GmbH
Installation guide - beyertone
®
multiLAN Ver. 3
6/40
2. Installation
The beyertone
®
multiLAN should be installed by authorised telephone system service
only. Proceed as follows:
2.1 MoH port
Set up the external port for music on hold on the PBX. Connect the PBX's MOH port
to the MOH port on the beyertone
®
multiLAN using one of the cables supplied. The
pin assignment on the beyertone
®
appliance is as follows:
The MOH input on the PBX can either be a voltage-free audio input (jack/RCA) or an
analogue a/b port (with feed). Both options can be catered for by the beyertone
®
multiLAN without the need to switch.
When connecting the music on hold to a HiPath 4000 (Hicom 300), please note the
different pin configuration (see table). Depending on the sensitivity of the system's
MOH port, it may also be necessary to switch the wires.
Never
use the RJ11 cable to connect the PHONE output on the beyertone
®
multi-
LAN to an a/b port. BEYERTONE accepts
no
liability for any damage caused to the
appliance as a result!
You can also connect headphones to the PHONE port to check the music playback.
Unlike the RJ output, however, the PHONE output is
not
galvanically isolated!
On power up, after booting (approx. 10 seconds) MOH playback starts automatically
as long as the appliance contains valid mp3 audio files. The appliance is shipped
with a royalty-free default track. The yellow 'MOH' LED flashes evenly on playback
of music. You should then check the music playback using the call hold function of
the telephone system.
To set the volume level of the music on hold, load own music files and make all
other settings, you have to use a browser via LAN (see Section 3, 4.1 and 5.1).
* HIC = connection MoH to HiPath 4000 / Hicom 300 („SSC“-port)
UAE 6/6
RJ 11/12
UAE 8/8
RJ 45
a/b or
audio
function
1
2
-
a-wire HIC *
2
3
-
3
4
a
a-wire / audio
4
5
b
b-wire / audio
5
6
-
6
7
-
b-wire HIC *
