Bexen Reanibex 700, Technical Manual

Page: 152 / 169

TECHNICAL MANUAL DGG 700 B
142
PATIENT
IMPEDANCE
Measurement of the
patient impedance has
not been correctly
carried out Check the instructions and carry out
the Hardware test again in order to
calibrate the impedance meter
Check the continuity of the patient
electrodes connection cable
Check the patient electrodes
connector to see if it is damaged
and/or broken
Check the connection of the
electrodes connector to the Power
Board (APEX and EXT connectors)
Check or replace the CPU board
MONITOR The signal acquired by
means of the
disposable electrodes
or the paddles is of bad
quality Check and if necessary replace the
paddles or the disposable electrodes
cable
Check and if necessary replace the
multifunction connector (MFC)
Check the connection of the
multifunction connector to the CPU
board
Check or replace the CPU board
The signal acquired
using the patient cable
is of bad quality Check and if necessary replace the
patient cable
Check and if necessary replace the
patient cable connector
Check the connection of the patient
cable connector to the CPU board
Check or replace the CPU board
The % SpO2 value is
not monitored Check or replace the pulse oximetry
sensor and/or the spiral cable
Check and replace the patient cable
connector if necessary
Check the connection between the
connector and the SpO2 board
Check the connection between the
SpO2 board and the CPU board
Check or replace the SpO2 board
Check or replace the CPU board