2
INSTALLATION
1. Insert batteries: Use a Phillips screwdriver to remove the top of the
charcoal cart (B), which is also the battery cover. Insert 4 identical 1.5V AA
batteries into the device. Make sure the polarity is correct when inserting
the batteries. After inserting the batteries, place the battery cover back.
1.
2.
3.
H
J
J
J
J
H
G
4.
K
K
5.
I
F
6.
7.
2. Check that the slide switch on the right side of the locomotive (A) is in the
„OFF” position. Use the hook to connect the coal car to the locomotive, then
connect the DC power cable between the coal car and the locomotive. This
ensures the energy supply to the locomotive. You can attach additional
carriages (C-D) using hooks.
3. Assemble the rail track (E) to obtain a continuous circular track. When
connecting the rails, make sure that they fit exactly. If you want to use
the product on the ground (around the Christmas tree), place the railroad
cars on the rail and turn on the product. If you want to fix the track to
artificial pine, set the finished track aside for a while while assembling
the cantilever section.
4. Assemble the trunk mounting bracket! Place the stabilizers (H) on one
side of the ring, then place the two-piece retaining ring (G) around
the trunk of the tree and fit them together so that they snap together.
Attention! Position the bracket with the stabilizers on the bottom. Fasten
the rings at the connection points with 4 screws (J - 20 mm).
5. Attach the bracket to the pine trunk using the four long screws (K - 60
mm) provided. Tighten the opposite screws at the same time. Tighten the
screws firmly, but do not overtighten, making sure the plastic parts are
intact. Verify that the console cannot move away from the trunk.
6. Now secure the levers (F) connecting the bracket and the rail track. Align
the elements from above with the appropriate part of the ring so that
the arms are up and out, ready to receive the previously assembled track.
Once all 8 levers have been secured, place the two-sided ring (I) at the
base of the arms to prevent the arm from falling out of place.
7. Place the rail track on top of the arms and snap the track under the
mounting tab on the top of the arms. We recommend that you hook up
the inner tab first and then push the outer one onto.
8. Place the trains on the track, make sure all wheels are on top of the rail, then turn on the locomotive. As a precaution, stay close to the train during
the first few laps to avoid possible damage.
