4
1. Mark the holes in the bracket on the wall
with a pencil, and then drill the holes. To
drill the holes, use a drill bit 6 and the
holes must be at least 35 - 40 mm deep.
2. Insert the included anchors and screw
in the screws. Leave a space of 4 - 5
mm between the screw and the plane
of the wall so that you can hang the
bracket securely! Make sure it is properly
fastened!
3. Make sure the top of the device is on top,
never install the device upside down!
The heating head of the appliance can
be tilted down at an angle of 60 degrees
according to your needs! Never adjust the
tilt angle during use! We recommend that you wait at least 15 - 20 minutes for the appliance to cool down completely before carrying
out such operations.
4. Use the included fixing accessories (anchor, screw) during installation. Deviations from these should only be made if the material of
the wall requires otherwise or you want to use a larger anchor or screw.
5. Mark the holes in the bracket on the wall with a pencil, and then drill the holes. To drill the holes, use a drill bit 6 and the holes must
be at least 35 - 40 mm deep.
6. Insert the included anchors and screw in the screws. Leave a space of 4 - 5 mm between the screw and the plane of the wall so that
you can hang the bracket securely! Make sure it is properly fastened!
7. Make sure the top of the device is on top, never install the device upside down! The heating head of the appliance can be tilted down
at an angle of 60 degrees according to your needs! Never adjust the tilt angle during use! We recommend that you wait at least
15 - 20 minutes for the appliance to cool down completely before carrying out such operations.
ON / OFF SWITCH
You can turn the device on and off by pulling the string. A slight vibration when turned on disappears after a few seconds, this is a natural
phenomenon. You can increase the heating capacity of the appliance by pulling the string again. You can find out the current level with
the help of the 1-2-3 indicator on the front of the device. After level 3, you will find the off state. The device is designed for residential use
and can only be used for periodic heating of rooms!
• Position 0: Stop
• Position 1: 650 W (normal performance)
• Position 2: 1300 W (medium performance)
• Position 3: 2000 W (Maximum performance)
If the appliance breaks down, contact a specialist! It is strictly FORBIDDEN to disassemble or modify the device. The
manufacturer and the distributor are not liable for damage resulting from improper use!
50 cm
50 cm
200 cm
