BC610 Installation and User manual
11
Programming
In the sections below are the instructions on how to program
BC610. To be able to program the card reader you have to set
the card reader to programming mode. This is done by
entering a six-digit code (see the next page).
Buzzer and LEDs
During programming you will be guided by the buzzer and the
LEDs.
In this manual the LEDs are illustrated in the following way:
!
= Off
"
= Lit
#
= Flashes
In programming mode before a function is chosen
: All three
LEDs are flashing.
###
During programming
: The LEDs are lit or off depending on
the function being programmed.
Correct programming
: Confirmed by a rising signal
consisting of two quick beeps.
Faulty programming
: Confirmed by a falling signal
consisting of one long and one short beep.
Note!
If, having entered programming mode, no key is
pressed within 20 seconds, the unit will leave programming
mode.
