7
Parts Replacement
TO ACCESS ELECTRICAL COMPONENTS:
1. Make sure the unit is turned off and disconnected from electrical service.
2. Disconnect drain line and remove coupling (see fig. 1 page 4)
3. Remove the two black handled knobs (one located on each side of the control panel).
4. Pull the module out from the cabinet.
Refer to drawings above for steps 5, 6 and 7.
5. Remove screws(3) and stainless steel drip edge.
6. Turn module over, and remove screws from the bottom of the module. (7 screws each side).
There will be (4) nylon caps and spacers, save and reuse.
7. Remove screws from the back side of control panel. (4 screws each side).
8. Carefully pull control panel forward.
After installing any new components, reverse the above steps. Make certain that the one inch air-flow
opening at the back of the module is up behind the cabinet's back vent hanging on the rear wall.
Refer to wiring diagrams for additional information.
Summary of Contents for Cinnabon PICA70-32-AED
Page 9: ...8 Amp rating 120v Models 13 amps...
Page 10: ...9 Amp rating 208 230v Models 7 5 6 8 amps...
Page 12: ...11 Notes...
