30
Beurer GL50
Evaluating measured values on the PC
1
The monitor must be switched off. Insert the
monitor’s USB connector into a free USB port on
your PC. In the event that the measuring device is not
recognised, please try using another active USB port.
2
“
” is shown on the display of the monitor. Saved
data can now be viewed on your PC.
3
See the information on evaluating values in the software manual.
7 s
torinG
,
maintaininG
and
disinfectinG
the
device
Storing
Keep the Beurer GL50 blood glucose monitor in the case supplied after each measurement and do
not expose it to direct sunlight.
Note
• Do not store the device, test strips or control solution in your vehicle, in the bathroom or in a cooling
appliance, if this would not comply with the storage conditions specified.
• Retain these instructions for use.
• Remove the batteries if you do not intend to use the device for a prolonged period of time.
• Only clean the device when it is switched off.
7.1 Maintenance
Clean the surface of the device using a soft, slightly damp cloth (water or a mild cleaning solution).
Dry the device using a lint-free cloth.
Make sure that moisture does not enter the test strip insertion slot. Do not spray cleaning products
directly onto the device. Do not submerge the device in water or any other fluids and make sure that
no fluids can get into the device.
7.2 Disinfection
Please comply with the generally applicable guidelines on disinfection when using the device on
different persons. Do not submerge the device in disinfection solutions or any other fluids and make
sure that no fluids can enter the device.
The cap on the integrated lancing device can be disinfected with 70–75% alcohol. Disinfect the cap
at least 1 x a week and submerge the cap in alcohol for approx. 10 minutes. Allow the cap to air dry.
