Beurer GL50
13
• Discontinue use of the test strips if one of the two expiry dates ( /
18 M
) has passed.
• You can touch any part of the test strip with clean, dry hands.
• Use the test strip for measurement immediately after removing it from the box/film packaging.
• Do not bend, cut or otherwise modify the test strips.
• Do not use test strips that have come into contact with fluids.
Storing test strips
Note
• Keep the test strips in a cool, dry place above +2°C and below +30°C. Do not expose the test strips
to direct sunlight or heat. Do not store in your vehicle, in the bathroom or in a cooling appliance.
• Permitted relative air humidity below 90%.
• The test strips must be stored in the original box/unopened film packaging – never use other
containers.
4 i
nitial
use
and
basic
settinGs
4.1 Removing the battery insulation strips, replacing the batteries
Note
• Two batteries are included in delivery of
the blood glucose monitor. These have
already been inserted into the battery
compartment.
• Remove the insulation strip before initial
use.
1
Carefully pull the lancing device and monitor apart.
2
Remove the battery compartment lid on the underside of the device. To do so, slide the cover
in the direction of the imprinted arrow.
3
When replacing the batteries, remove all batteries. The
device retains the date and time as long as one battery
is still inserted. If applicable, reset the date and time (see
“4.2 Adjusting basic settings” on page 14).
CR2032
CR2032
4
Insert two new
CR 2032 3 V
batteries. Make sure that the batteries are inserted the correct
way round in accordance with the markings. Observe the graphic in the battery compartment.
5
Close the battery compartment lid again carefully.
6
Fit the lancing device and monitor back together.