Bettis P/N 127073E
Revision “A”
Page 4 of 37
.
1.5
SERVICE SUPPORT ITEMS
1.5.1
Bettis Module Service Kits.
1.5.2
For rod extension retainer nut tool part number, refer to the following table. NOTE: These
tools are required only when extension rod assembly (1-50) or (9-50) is removed or when
a new extension rod assembly is installed.
ACTUATOR
MODEL
BETTIS PART
NUMBER
ACTUATOR
MODEL
BETTIS PART
NUMBER
G01
None required
G5/G7
117369
G2
123616
G8/G10
117368
G3/G4
117370
1.5.3
Commercial leak testing solution.
1.5.4
Non-hardening thread sealant.
1.6
LUBRICATION AND FLUID REQUIREMENTS
NOTE: Lubricants and Fluids, other than listed in step 1.6.1 and 1.6.2 should not be used without
prior written approval of Bettis Product Engineering.
1.6.1.
All temperature services (-50°F to +350°F)/(-45.5°C to 176.6°C) use Bettis ESL-5
lubricant. ESL-5 lubricant is contained in the Bettis Module Service Kit in tubes or cans
and they are marked ESL-4,5 & 10 lubricant.
1.6.2
M11 Manual Hydraulic Override System Fluid Requirements: Temperature service (-35
°
F
to +350
°
F) use Dexron Automatic Transmission Fluid.
1.7
GENERAL TOOL INFORMATION
1.7.1
Tools: All tools/Hexagons are American Standard inch. Large adjustable wrench, two (2)
large screwdrivers, Allen wrench set, set of open/box-end wrenches, rubber or leather
mallet, torque wrench (up to 1200 foot pounds / 1627 N-m), breaker bar, small drift punch
and a drive socket set. For recommended tool and wrench sizes refer to Section 6, Tables
6.3 through 6.10