32
BetterOutdoorProducts.com
12. Using needle nose pliers, remove the cotter pin
securing the brake yoke to the brake lever
Figure
65
.
Figure 65
13. Using a 1/2” wrench and 1/2” socket, remove the
four nuts securing the hydro pump to the lower
support
Figure 66
.
Figure 66
14. Using a 7/16” wrench and Phillips head screwdriver,
remove the dump valve lever and install it on the
new hydro pump
Figure 67
.
Figure 67
15. Using a 9/16” wrench and 9/16” socket, and a 5/8”
wrench and 5/8” socket, remove the bolts securing
the hydro arm to hydro pump
Figure 68
.
Figure 68
16. Remove the hydro arm and install it on the new
hydro pump.
17. Install the hydro pump back onto the lower support.
Note:
It is important to follow these steps in order
for the hydro pumps to seat properly. Install the two
bolts that connect the hydro pumps and then back
off one full turn. Install the four bolts that secure the
hydro pump to the lower support and tighten.
Tighten the two bolts connecting the hydro pumps.
18. Reinstall the hydro assembly in the reverse order,
making sure that the dump valve levers and parking
brake go back into their respective slots. Also, make
sure that the belt seats in the idler pulley and both
hydro pump pulleys.
