49
BRUSH ASSEMBLY ADJUSTMENT
1. Verify that when the foot lever is locked in the brush deck up position the
micro switch
is activated and the micro switch actuator has 0.5 mm of travel
remaining.
2. If necessary adjust the micro switch as follows:
• Unscrew
the
nyloc M3 nut
and the
M3 screw
.
• Adjust the micro switch.
• Tighten
the
nyloc nut
and the
M3 screw
.
• When the adjustment is fi nished verify the proper functionality of the micro
switch.
3. Adjust the
belt tensioner spring
to a length of
27 mm
in compression.
4. Adjust the transversal inclination of the brush deck:
• Put the machine on a level fl oor.
• Lower the brush base on the fl oor with brushes installed.
• Loosen
the
bolt and the nut M8
on the left brush deck lifting arm.
• Lower the brush deck to allow the two brushes lay on the fl oor evenly.
• Tighten
the
M8 bolt
.
5. Verify that the shown bolt allows the brush deck to fl oat evenly on the fl oor.
6. Verify that the brushes can be removed from the brush deck if necessary:
• Lift up the brush deck.
• Loosen the M6 jam nut.
• Adjust
the
M6 bolt
until the brushes have enough space to be removed from
the brush deck.
• Verify that with the brush base does not interfere with the solution tank.
Summary of Contents for Stealth ASD26BT
Page 36: ...36 SOLUTION CONTROL DIAGRAM 11 23 9 19 21 13 20 6 5 15 16 4 1 22 10 3 14 8 1 8 2 17 12 18 2 ...
Page 44: ...44 ELECTRICAL DIAGRAM ...
Page 54: ...54 ...
Page 55: ...55 ...
