17
4. CLEANING THE SQUEEGEE
Ensure the squeegee is always clean, to improve drying results.
To clean:
A. Remove the squeegee vacuum hose from the squeegee shoe adapter.
B. Remove the cotter pins that attach the pins of the squeegee shoe.
C. Disassemble the squeegee from its support.
D. Loosen the wing nuts (
1
).
E. Remove the squeegee band clamp and squeegee blade.
F. Replace the squeegee blades.
To reassemble the squeegee, repeat the operations in the reverse order.
WARNING: Always wear gloves when doing this operation to pro-
tect yourself from contact with hazardous chemicals.
5. REMOVING THE PAD DRIVERS
A. Turn the key to the “off” position.
B. Raise the brush deck using the foot lever.
C. Rotate the brush until it comes out of the clutch as shown in the fi gure. The
fi gure shows the rotation direction to release the right-hand brush; for the
left-hand one, rotate in the opposite direction.
WARNING: Always wear gloves when doing this operation to pro-
tect yourself from contact with hazardous chemicals.
6. REPLACING THE SQUEEGEE BLADES
Check the state of wear of the squeegee blades and, if necessary, replace them.
To replace:
A. Remove the squeegee hose from the squeegee shoe adapter.
B. Push the release lever and release the right hand stud.
C. Remove the squeegee vacuum from the squeegee yoke.
D. Loosen the wing nuts.
E. Remove the squeegee band clamp and squeegee blade.
F. Replace the squeegee blades.
To reassemble the squeegee, repeat the operations in the reverse order.
WARNING: Always wear gloves when doing this operation to pro-
tect yourself from contact with hazardous chemicals.
DAILY MAINTENANCE
Summary of Contents for Stealth ASD26BT
Page 36: ...36 SOLUTION CONTROL DIAGRAM 11 23 9 19 21 13 20 6 5 15 16 4 1 22 10 3 14 8 1 8 2 17 12 18 2 ...
Page 44: ...44 ELECTRICAL DIAGRAM ...
Page 54: ...54 ...
Page 55: ...55 ...