Bestway PRO-MOUNT 360, Operator'S Manual

Page: 25 / 91

C6
5. Follow the directions in the sprayer control operating manual to calibrate and set the controller.
6. Fill the sprayer half full of water using the quick fill port (see filling the sprayer in the
“Operation” section). Also, fill the rinse tank (if equipped) and the personal wash tank. Check for
leaks around all tanks and valves.
7. Make sure the tank suction valve is turned on, allowing water to flood the pump inlet. Start
the tractor engine. Turn the oil flow on the tractor remote down to a low setting. With all the
valves closed (agitation, rinse, boom sections), engage the pump by actuating the appropriate
hydraulic remote valve and adjust the tractor rpm to the speed that will be used when spraying. Do
not continue to operate the pump if pressure is not indicated immediately on the pressure gauge in
the front of the sprayer. Slowly increase the hydraulic flow of the tractor remote until the gauge
shows 110#-120# of pressure. DO NOT EXCEED 120#! After the pressure is set, adjust the agita-
tion valve to 1/2 open.
8. Unfold boom slowly and carefully (See boom operation in the “Operation” section).
Position boom so the nozzles can all be observed easily.
Make sure no person or object is in the path of the
wings, especially when folding or unfolding. Be aware of
the boom location at all times. Stay away from power lines when folding or unfolding
wings. Always retract and lock wings except during application.
Make sure when unfolding boom, sprayer is attached to a
tractor.
WARNING:
!
DANGER:
!