Bestway 58515, Owner'S Manual

Page: 8 / 56

Assembly
(You will need a screwdriver.)
1. Carefully remove all components from the package and check to
ensure nothing is damaged. If equipment is
damaged,immediately notify the retailer from
where the equipment was purchased.
2. The sand filter should be placed on solid, level
ground, preferably a concrete slab. Position the
sand filter so the Ports and Control Valve are
accessible for operation, servicing and
winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically
fixed on ground or a certain pedestal made of wood or concrete
before use to prevent the sand filter from accideutally falling. Fully
assembled sand filter will exceed 18 kg. The mounting holes should
be 8 mm in diameter and spaced 285 mm apart. Use two bolts and
nuts with a maximum of 8 mm in diameter to fasten the sand filter to
the pedestal.
8
Ø 8 mm
285 mm
Load pool-grade filter sand/Flowclear™ Polysphere.
NOTE:
Use only special pool-grade filter sand, free of all
limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately
one 8.5 kg bag should suffice. If you do not use the
recommended size filter sand, filtering performance will be
reduced and the sand filter may damaged, thereby voiding
warranty.
NOTE:
To avoid damaging the Skimmer when adding sand,
pour some water into the Bottom Tank to submerse the
Skimmer on the Collector Hub.
NOTE: Sand/Flowclear™ Polysphere not included.
NOTE:
Use 28 g (0.06 lbs) Flowclear™ Polysphere to replace 1 kg
(2.20 lbs) sand.
MAX
MIN
#20
0.45-0.85 mm
C
C
C
C