Supertop for Truck Installation Instructions
Rev. G 0713
76303 pg. 5
Place a 1/4" Fender Washer over the 1/4" x 1-1/2"
Clevis Pins installed in the Bow Mounts. Slide the
legs of the Front Bow Assembly over the Clevis Pins
and secure them with 1/4" Flat Washer and a Hitch
Pin Clip on each side of the vehicle.
Install Front Bow
Install Rear Bow Assembly
Front Bow
Assembly
Bow Tie
Down Strap
1/4" Fender
Washer
1/4" Flat
Washer
Hitch Pin
Clip
Rear Bow
Assembly
5/16" Flat
Washer
Hitch Pin
Clip
Cut Web Strap Reinforcement
Place the top fabric on a safe, clean cutting surface.
Locate the two (2) wide patches in the seal below
the window on the front panel of the top. Use a util-
ity knife to cut a slit through all the layers following
the indent in the seal.
Front Window
Cut slit in
reinforcement
Install Buckle Straps
Locate the two (2) 32" Buckle Straps in the parts
kit. Thread the end of each strap through the slits
from the vinyl (outside) side of the top. Pull the
straps through the slits until the back of the buckle
is against the slit.
Pull Strap
Through
Locate the two (2) Elastic Garters in the parts
kit. Slide a garter over each half of the Rear
Bow from the center so that the Garters will
hang above the rear window opening. Slide
the long tail of a Tension Strap onto each short
bow half and the buckle end onto the rear bow
half. Adjust the straps so there is about 3" of
strap beyond the buckle.
Slide the two (2) halves of the Rear Bow into
the remaining Bow Couplers. Slide the legs of
the Rear Bow Assembly over the 5/16" x 3/4"
Clevis Pins and secure them with a 5/16" Flat
Washer and a Hitch Pin Clip on each side of
the vehicle.
Tension
Straps
Elastic Garters
