Supertop for Truck Installation Instructions
Rev. G 0713
76303 pg. 8
We recommend that the
Third Brake Light sup-
plied with this assembly
be professionally wired.
Locate the plastic clips sewn into the rear corners
of the top. Gently pull down on the rear bow and
pull down and back on the fabric to hook the clips
into the corner of the Tailgate Bracket on the Belt
Rail Assembly. Locate the plastic strip next to the
clip and hook it into the channel on the Side Belt
Rail. Make sure as you do this that the corner clip
remains hooked into the corner retainer.
Secure the Rear of the Top
Use a 0.136" drill bit to drill out the two dimpled
holes in the plastic mounting pad on the Third
Brake Light. Orient the Third Brake Light so that
the pad is horizontal along the Rear Bow and in the
center. Peel the backing tape off the bottom of the
mounting pad and press it onto the bow.
Drill 0.136"
Holes
Press Light onto
center of Rear
Bow
Install Third Brake Light
Tailgate
Opening
Plastic Strip - Slip into
channel in Belt Rail
Hook clip into
Tailgate Bracket
Use the holes in the Third Brake Light mounting pad
as a guide to center punch two holes in the Rear
Bow. Drill a 0.136" hole at each of these locations.
Install a #8 x 1/2" Self Tapping Screw at each of
these locations.
Unsnap the snap fl aps from the Rear Bow on the
driver side of the brake light. Run the wire from the
light along the bow and snap the fl aps around the
bow and the wire. Wrap the wire around the bow
down to the pickup bed rail.
Drill 0.136" Hole and
install #8 x 1/2" Self
Tapping Screws
Thread Wire through
Snap Flap
Secure Third Brake Light to
Rear Bow
