EZ Roll Tonneau Installation Instructions
Rev. A 0711
17182 pg. 5
Once the Frame is centered reach between the
cover and the Side Rail to access the center and
rear clamps. Tighten the 5/16" Bolt in the Clamp
until the Lock Washer is compressed, then add 1 to
1-1/2 additional turns to reach optimum pressure.
Repeat on both sides of the vehicle.
Secure Remaining Clamps
Do not remove the cover until all clamps
are tight.
Fasten the loop strip sewn to the driver’s side of the
Tonneau Cover to the hook on the Side Rail. Pull the
fabric tight across and secure the passenger side.
Secure Sides of Cover
Make sure to keep the fabric tight across
the bed to ensure a proper fi t.
Open the tailgate and pull the latch to the rear to
disengage the Rear Rail.
To Remove Cover –
Release Latch
Tightly roll the Cover toward the front and buckle the
Tie Down Straps.
To Remove Cover –
Roll Cover
Reach under
Cover to
Tighten
Clamps
Fasten Hook
and Loop
Pull
Latch
Make sure the Cover fabric is released from the
hook on the Side Rails. Loosen the wing nuts on
each side of the Front Rail. Slide the latches toward
the center of the vehicle until they release from the
Side Rails.
To Remove Cover –
Release Front Rail
Loosen Latch on
Both Sides and
Slide to Center
