EZ Roll Tonneau Installation Instructions
Rev. A 0711
17182 pg. 4
With the Tonneau Cover Assembly latched on both
sides, push both Side Rails in so they are fl ush
with the Front Rail. Center the front of the Frame
from side to side on the vehicle.
Center Tonneau Frame
Rotate the Rear Rail into the rear Pivot Mounts on
both sides. It will only latch on the driver’s side.
Secure Rear Rail To Rear
Pivot Mounts
Tighten the front Clamp on each side until the Lock
Washer is compressed.
Tighten Front Clamps
Tighten Front
Clamps
Roll out the cover. Make sure that each bow falls
between the Side Rails.
Roll Out Cover
Bow
Side Rail
Push the Side Rails fl ush against the Rear Rail and
center the rear of the Frame from side to side on
the vehicle.
Center Rear of Frame
Rotate Rear Rail
into Pivot Mounts
Center Frame
from Side to Side
Center Frame
from Side to Side
