BEST Range Hoods U102I, Manual

Page: 4 / 44

- 4 -
OPERATION
For quiet operation and best capture of smoke, steam and other cooking impu-
rities, always operate this unit with the slide-out visor fully open.
Controls
The hood is operated using the (5) push buttons located on the slide-out visor.
The Light O ff /On switch turns the lights on to low intensity and turns them o ff .
The Light Dimmer switch alternates light intensity from low to high.
The Blower O ff /Speed switch turns the blower o ff and changes blower speed to
four di ff erent speed settings: high, medium-high, medium-low and low speed.
Depress and hold the button for 2 seconds to turn the blower o ff .
The Blower On/Speed switch turns the blower on to four di ff erent speed settings:
Low, medium-low, medium-high and high speed. The visor must be open for the
blower to be operational.
The LED Display :
Indicates blower speed selection from 1 (lowspeed) to 4 (high speed).
Flashes the blower speed when the 10-minutes delay o
ff has been activated.
After 30 hours of operation, the center segment of the display blinks and remains
lit, indicating that
fi lters need to be cleaned.
The Time Delay switch activates a delay o ff feature. When pushed, the blower will
continue to operate at the current speed setting for 10-minutes before automatically
turning itself o
ff .
The Filter Alarm Reset switch is used to reset the 30-hour fi lter timer. After fi lters
are cleaned or replaced, press this switch once to reset the fi lter clean alarm.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING : The HEAT SENTRY thermostat can start the blower even if
the hood is turned OFF. When this occurs, it is impossible to turn the blower
OFF with its switch. If you must stop the blower, do it from the main electrical
panel.