BEST Range Hoods U102I, Manual

Page: 11 / 44

- 11 -
INSTALL FILTERS
(NON-DUCTED HOODS ONLY)
1. Install a charcoal fi lter on each side of the
blower (included with Nonducted Recircula-
tion Kit Model ANKU10).
2. To install the charcoal fi lter, align two keyhole
slots on the fi lter with locking tabs on the
blower. Rotate to lock fi lter into place.
3. To remove the charcoal fi lter, rotate the fi lter
until it disengages from the blower.
NON-DUCTED RECIRCULA-
TION FILTERS
INSTALL ELECTRICAL
WARNING: All electrical wiring should
be done by a quali fi ed person (s) in accor-
dance with all applicable codes and stan-
dards. This range hood must be properly
grounded.
1. Run 120 VAC electrical power cable to the
hood’s wiring box.
2. From inside the hood, remove the wiring
box cover.
3. Secure the conduit to the wiring box through
a conduit connector.
4. Make electrical connections at the hood.
Connect white-to-white, black-to-black and
green to ground.
5. Replace the wiring box cover and screws.
Make sure the wires are not pinched be-
tween the cover and box.
6. Connect power at the service entrance and
check hood for operation.
!
GREASE
FILTER
INSTALL FILTERS ,
cont’d
(DUCTED AND NON-DUCTED HOODS)
To remove the GREASE fi lter, grip the latch
tab and pull it down. This will disengage the
fi lter from the hood.
To install the GREASE fi lter, align fi lter tabs
on the side of the fi lter with slots in the hood
drawer. Pull latch tab down, push fi lter up into
place and release the tab.
Make sure the
fi lter is securely engaged after
assembly.