STEP 10: PREPARING THE COVE
Using neutral alkalinity sifted earth of fine sand without
pebbles, build a 2" base over the entire pool area to protect
the liner. Make sure that the straps and hold down plates are
covered entirely. If base does not fully cover the metal com-
ponents, they may show through and possible damage the
liner. If using vermiculite base, you must have at least two
inches of soil or sand on top of straps and hold down plates.
Vermiculite alone will not properly cover these metal compo-
nents, possibly allowing damage to the liner. Do not use any
substance with high alkaline or acid content.
Next, using sifted earth or fine sand, build a pool cove 6"
to 8" inside the metal wall along the entire circumference. We
recommend that you start this in the middle of the straight
sides and work your way towards the round sections. This
will help to push the wall firmly against the hold down plates
making the hanging of the liner easier. The cove will prevent
the liner from creeping under the wall and will also protect
the liner from any metal corners of the pool framework. THIS
STEP IS NOT OPTIONAL - IT MUST BE DONE! Since earth
containing chemicals can cause discoloration or corrosion, it
is suggested that you place polyethylene plastic sheeting
under the cove around the perimeter of the wall, so no earth
comes in contact with the metal. Since the presence of such
chemicals is beyond the control of the manufacturer, such
damage is not covered by the warranty.
8”
8”
2”
TOP RAIL
POOL WALL
HOLD DOWN
PLATE
LINER
SAND COVE PROTECTS THE
LINER FROM THE METAL
WALL & HOLD DOWN PLATE
