!
Leveling Blocks
It is important that the floor be level and square.
Before nailing the flooring, measure the floor
diagonally (corner to corner). Then measure
the opposite corners. These measurements will
be the same if the floor is square (226-1/2").
2.
Cut the 2x4-10' floor joist to 9'-9". Treated lumber may be thicker than 1-1/2". Take this into
account when cutting the length of floor joists. Shorten joist measurements if necessary to
obtain 10'-0" building width.
1.
Treated lumber is not cut to exact length. Cut (2) two 2x4-16' boards to 16'-0".
Layout for 16" on center joist spacing. 'X' marks where floor joist will be placed.
Construction Details for Optional Floor System
Check local building codes, the construction may have to change. For a concrete slab, install sill
sealer as a moisture barrier between the concrete and the wall plates. Foam sill sealer can be
purchased at home centers in rolls 3-1/2" or wider. DO NOT make floor larger than shown below!
Material Description
10' x 16' Floor
2x4 Treated Headers
2 pcs.
16'
2x4 Treated Floor Joist
13 pcs.
10'
Flooring 5/8" 4x8
5 pcs. 4x8
8d Screw Floor Nails
2 lb.
8d
16d Galv. Box Nails
2 lb.
16d
If necessary use bricks, patio stones or similar material to level or provide additional support
to the floor. If your ground has low areas consider adding gravel and or 4x4 treated timbers
to rest the floor on. If you use 4x4 timbers you will need (3) three pieces 16' long.
3.
Install the floor joist, over the 'X' marks, between the 16' long joist headers. Use 16d galv.
deck nails.
!
Joist 9' - 9" Long
2x4-16' Joist Header
16' - 0" Floor Length
10' - 0" Floor W
idth
4' x 8'
4' x 4'
4' x 8'
2' x 8'
4' x 8'
X
X
X
X
X
X
16"
15-1/4"
Joist Header
X
X
16"