Ultraview US23-0640-09
07-30-09
V4
© Copyright 2009 Besam US Inc. May not be reprinted without permission
8
Remote Control
The remote control provides ease of programming for the Ultraview. Make sure
the batteries in the remote control are charged - replace as necessary.
Open the battery compartment at the back of the remote control.
Insert 2 AAA batteries.
1:normal
(LED in normal mode)
2:door permanently open
(red LED ON)
3:door permanently closed
(red LED OFF)
Door Control
0(min)->9(max)
default=7
Sensitivity
Microwave
Detection Mode
1:bidirectional mode
2:unidirectional mode
3:unidirectional mode with MTF
Setup
launch an assisted setup
restore factory settings
When restoring factory defaults(Magic
Wand+9), the sensor will self-launch a
setup, but will not change the designation
of P1 and P2
Automatic
Learn Time
0: 30 seconds
1: 1 minute
2: 2 minutes
3: 5 minutes
4: 10 minutes
5: 20 minutes
6: 60 minutes
9:Infinity - no learn
Re-entry Zone
1(min sensitivity)->9(max sensitivity)
Default=3
0 = off
Unlock
Check values
Lock
SPECIAL NOTE: In the event you believe the frequency needs changed
for your application please contact the Besam factory.
