Component Identification
Electrical Installation
Connect the Extension Harnesses to the Ultraview Interface Board at the control as follows:
1. Designate the sensors as P1 or P2.
Important:
The side of the door “not intended for use” when door is in one-way mode will be
designated P2.
2. The longer extension harness has a gray jacket and will be connected to the sensor on the
plank side. The shorter extension harness has a black jacket and is connected to the header
access side. Based on Step 1, connect the appropriate extension harness to the appropriate
connector on the Ultraview Interface Board.
Ultraview US23-0640-09
07-30-09
V4
© Copyright 2009 Besam US Inc. May not be reprinted without permission
4
MOUNTING SCREWS
INFRARED LENS
SHROUD
SENSOR
COVER
ULTRAVIEW
INTERFACE BOARD
QUICK DISCONNECT HARNESS(2 per system)
SHORT (black)
EXTENSION HARNESS
LONG (gray)
EXTENSION HARNESS
WIDE IR US21-0640-07
NARROW IR US21-0640-08
US02-0640-01
US21-0640-06
US02-0640-02
US02-0640-05
DIP SWITCH
STOP/IMPULSE(BREAKOUT INPUT)
P2
P1
STD/AUX SWITCH
KNOWING ACT INPUT (AUX)
US02-0640-04
US02-0640-03
Ultraview Replacement Sensor Kit
-
US15-0640-14
One assembled unit consisting of sensor, shroud, cover, wide lens, narrow lens,
mounting screws and quick disconnect harness.
(Not available as a spare part)
(Not available as a spare part)
