Berthold 55393 BA2, Operating Manual

Page: 44 / 126

Quick Start LB 983 NightSHADE II Operating Manual
44
Adjust the required intensities and click on
to accept the parameters. The control com-
mand will show up in the work flow list.
When all commands are set close the dialog box and save the template by clicking on
.
Please note that while a control sequence is running no measurements can be performed. To
simulate a day/ night cycle several templates with single commands must be defined to allow
measurements inbetween the control steps.

Artificial Daylight
This command sets the LED illumination panel to a defined intensitiy. The used intensi-
ties are temporarily saved for future use.

Daylight Off
Turns off the LED Panels and memorizes the intensities set before. Should be added to
a project as Pre-Measurement action to make sure the artificial daylight is off while
measuring.

Daylight On
Sets the LED panels to the last used intensities saved during the
“Daylight off” com-
mand. Should be added to a project as Post-Measurement action to make sure the arti-
ficial daylight is turned back on after a measurement.

Illumination
Controls the intensity of the white or infrared LEDs in the dark room for photographic