Step 6 Preparing The Dishwasher
1. Ensure that the circuit breaker and water supply valve are turned off before proceeding with the
following steps.
Before you move or lay down the dishwasher for installation, make sure to adjust the height of
the legs so the legs are as short as possible. This prevents the legs from breaking. Level the
dishwasher by adjusting the height of the legs after you have the dishwasher in place.
2. Make sure there are no kinks and that the hose is not bent at any extreme angles that could
constrict the flow of water.
3. Remove the junction box cover located at the bottom front right of the dishwasher using a
screwdriver, and then Install the strain relief (Figure 4 - C). Make sure to keep the junction box
cover you removed. It is used in Step 11, Wiring Connections.
4. If the countertop is made of wood or a material that is not damaged by drilling, attach the two
Installation brackets that were supplied with the dishwasher using the supplied
screws (Figure 4 - A). They will be used in Step 9. Securing the Dishwasher.
Do not overtighten the
90
°
Elbow.
Doing so may damage the water inlet valve
and cause a water leak.
1
2
15
Summary of Contents for DW18PR
Page 1: ...Ü DW 18PR ...
