Bernina B 580, Manual

Page: 161 / 194

160
Troubleshooting
Sewing-/
Embroidery
computer
Sewing-/
Embroidery
computer
Upper thread
indicator does not
respond
Lower thread
indicator does not
respond
Update error
̶ Sewing computer fails to run or runs slowly
̶ Turn power switch to «0» (off)
̶ Deleting or overwriting data, e.g.
drawers
̶ Stitch number not known in direct entry
̶ Stitch selection not possible in the
combination mode
̶ Raise the presser foot
̶ Lower the presser foot
̶ Not activated in the Setup Program
̶ Not activated in the Setup Program
̶ USB stick is not recognized
̶ Update process is blocked (hourglass
stays on display)
̶ Update-data aren't identified
█
alter the speed control
█
place the sewing computer in a warm room one hour before use
█
turn the power switch to «I» (on)
█
take the sewing computer to the nearest authorized
BERNINA dealer
█
confirm with or cancel with
█
check command entered and enter a new number
█
make another selection
█
the presser foot is raised
█
the presser foot is lowered
█
activate in the Setup Program
█
activate in the Setup Program
█
use a BERNINA USB stick
█
remove the stick and turn the sewing computer off and on
again. Proceed with the update as indicated by the message
█
don't save update-data in a folder
█
unzip update-data
Fault Cause Repair
General Explanation Repair Messages
Display is inactive ̶ Calibration data incorrect
̶ ECO-function active
█
re-calibrate the Display in the Setup Program
█
turn off ECO function
Stitch width not
adjustable
̶ Setting activated in the security
program
█
deactivate setting
Lower thread
indicator reacts
̶ Thread used/broken
̶ Bobbin inserted incorrectly
̶ Brake spring is missing
█
wind thread and thread
█
insert bobbin correctly
█
insert brake spring into bobbin case
LED sewing light
do not light up
̶ LED defective
̶ deactivated in the Setup Program
█
take the sewing-/embroidery computer to the nearest
authorized BERNINA dealer
█
activate in the Setup Program
033527.53.04_2014-07_Manual_B580_EN