Bernina Artista 185, Manual

Page: 8 / 138

Setting up the machine 8
To remove
· raise the needle
· turn power switch to “0”
· open the bobbin cover
· grasp the latch of the
bobbin case
· remove case
Bobbin case
To insert
· hold the bobbin case
latch
· the opening on the case
should be at the top
· insert so that it engages
· close the bobbin cover
Bobbin thread cutter
· insert the bobbin case
· take thread over cutter (A)
· cut thread
Note:
For normal sewing, the
bobbin thread does not
have to be brought up as
the loose end is just the
right length to start sewing.
Inserting the bobbin
The bobbin must turn
clockwise when the thread
is pulled. Insert the bobbin so that
the thread runs clockwise. Pull the thread counter-
clockwise into the slot. Pull the thread to the left
under the spring until it
lies in the T-shaped slit at
the end of the spring.
Winding the bobbin
Winding the bobbin
· turn power switch on
· place empty bobbin on
spindle
Thread cutter
· cut the thread on the
thread cutter
Threading the bobbin
· following the direction of the arrow take thread through
the rear guide and round the pre-tension stud
· wrap the thread around the inner bobbin two or
three times and cut off any excess thread on the thread
cutter
· press the engaging lever against the bobbin
· press the foot control
the motor stops automatically when the bobbin is full
· remove the bobbin
A
Warning:
If your sewing computer is
equipped with an embroidery
bobbin case, thread the bob-
bin thread in the guide spring
only when the embroidery
module (optional accessory)
is in use.
Refer to the safety
instructions!
185_BA_engl 16.4.2004 11:30 Uhr Seite 8
030866.51.04_0401_a185_EN