Bernhard ANGLEMASTER 3000DX, User Manual/Instruction Manual

Page: 10 / 43

10
ANGLEMASTER • AM3000DX
© Bernhard and Company Limited
3. Setting Up
(Continued)
3.2.4 There are two alignment stops at the front face of the mounting bar. Rotate the tabs so that
they stand above the top face of the mounting bar.
3.2.5 Using the bedknife, draw the stops out as far as they will go
(only slight pressure is required). Adjust the nut on the back
of the stops to adjust the travel.
The bedknife should be set to overhang the mounting bar
such that the back of the trough lines up with the edge of
the mounting bar (the leading edge of the bedknife will be
around 3/8” - 1/2” forward of the front edge of the mounting
bar). This should ensure that the stone will not grind the back of the bedknife.
3.2.6 Switch on the electromagnets. The bedknife assembly is now held so that it can be easily
mounted.
3.2.7 Universal Brackets
If using the Universal Bedknife Mounting Brackets:
Slide the mounting bracket assembly to the bedknife
assembly and locate bedknife using tapered pin or cup
support (according to it’s mounting type).
3.2.8 Lock the bracket end to the Anglemaster mounting bar,
then lock the support plate in position using locking knob
/ adjustable lever.
3.2.9 Rotate the mounting bar forward to improve
to improve access and adjust the height and
angle of the jacking screw assembly so that
the jacking screw end extension aligns with
a suitable point on the back of the bedknife
assembly. Lock in position with 2 knobs.
Loosen locking nut, adjust jacking screw against
the rear of the bedknife assembly with just
enough pressure to keep the lower front of the
bedknife assembly against the Anglemaster
mounting bar (to stop it swinging when the bar is
rotated) re-tighten locknut.
Jacking screw against bedknife
(Bar shown rotated to vertical position for clarity)
��
��