36
Embroidery Selection
BERNINA CutWork Tool*
* The BERNINA CutWork Tool accessory is optional. It is not included with this machine.
Turn power switch to off («O») when carrying out any of the
following operations.
The CutWork Tool is a very sharp accessory. Special care is
required when working with this tool and keep fingers away
from the sharp knife. Please consult you in CutWork book
packed with the CutWork Tool accessory.
Preparation
Attach the Darning/Embroidery foot
•
Loosen the needle clamp screw (a) to remove the
needle.
•
Turn the CutWork Tool between no. 1 and no. 2.
•
Insert the CutWork Tool with the flat side back, fully up
to the top (b).
•
Tighten the needle clamp screw (a) again.
•
Turn the CutWork Tool back to no. 1.
•
Attach the embroidery module
In CutWork Mode the upper thread sensor is disabled.
When a CutWork Design is selected the machine makes all
necessary settings automatically.
Do NOT change the needle plate to work with CutWork.
A
ttention
!
n
ote
n
ote
111
b
c
